Delphi SA10116-11B1 Manual de usuario descargar pdf (Pagina 16)

section three 6

Mounting

Your transmitter may rest flat on a horizontal surface, or it may be wall-

mounted. To mount on a wall, insert two screws (provided) 2" apart in a

horizontal line, leaving the screw heads approximately 1/4" from the wall.

Slip the two holes located on the bottom of the transmitter over the

screw heads and gently slide the unit down until it locks into place. (See

figure 3.)

Note: The screws that came with your Signal Repeater may be fastened to wallboard or

wood with an ordinary Phillips screwdriver; no pre-drilling is necessary. To fasten into

concrete, hollow or grout filled block, brick, or plaster, pre-drill a 3/16" hole and fasten

with an ordinary Phillips screwdriver.

Figure 3.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Sin comentarios

Delphi SA10116-11B1 Manual de usuario Pagina 16