Delphi SKYFi2 - XM Vehicle Kit Guía de instalación descargar pdf (Pagina 12)

Removing car cradle mount from your

dashboard

You can remove the car cradle mount from

your dashboard by taking the following steps:

1. Lift one edge of the adhesive pad gently

with fingers or the rounded edge of a

spoon. Once enough of the edge is loos-

ened to grip with your fingers, pull the

pad gently from the mounting surface at

a 90-degree angle. Avoid using sharp

tools that could damage the car interior.

2. If the pad fails to loosen, first warm it

with a hair dryer for 2 minutes to 3 min-

utes to soften the adhesive. Be careful

not to apply too much heat, which could

damage the mounting surface.

3. If any adhesive remains on the dash-

board surface, the adhesive can easily

be removed by rubbing your thumb or

finger across it.

4. As necessary, apply a silicon coating,

such as Armor All

protectant, to the

dashboard surface in order to restore

its shine.

Caution: Never use a commercial heat gun or

paint-stripping gun. This could result in damage to the

unit or to your vehicle.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Delphi SKYFi2 - XM Vehicle Kit Guía de instalación Pagina 12